King Controls King-Dome Sea-King, Troubleshooting Manual

Page: 11 / 28

Page 9
SYMPTOM POSSIBLE SOLUTION
Display reads “EL FAULT.” Make sure shipping tie strap is removed (back left hand side of dome unit).
Disconnect power supply for 15 seconds, then reconnect.
Perform Mechanical Calibration (page 12).
Restart system. If problem persists, perform OPTION 21 RE-INITIALIZE
and 0-RECALIBRATE (pages 10-11).
Reseat ribbon cables inside dome unit.
Only getting signal on 1/2 of
transponders.
Verify coax cables are tightly crimped with RADIAL (COMPRESSION) style
crimps only.
Verify receiver is operating properly.
Verify LNB type is set correctly.
Unit never locks on or locks on
and drifts off of satellite. Atmospheric moisture. Unit will lock on as weather improves.
Check for obstruction in sky in direction of satellite. Select another satellite
and verify unit locks on.
Verify coax cables are tightly crimped with RADIAL (COMPRESSION) style
crimps only.
Perform OPTION 21 RE-INITIALIZE and 0-RECALIBRATE (pages 10-11).
Perform Temperature Calibration . Call King Controls at (800) 982-9920.
Inspect all coax cables and verify connections are snug but not overly tight
(inside and outside dome unit).
9762 and 9762-SW ONLY: Verify De-stacker is installed (see Page 14).
IMPORTANT! The De-stacker must be installed even if only one
TV and receiver are used.