5/16”x2 1/2”
Right Corner
3-Way
Left Corner
3-Way
L
R
F
A
B
A
B
E
5/16”x1 1/2”
Step B
Starting with the center section connect all “C” and “D” pipe together and to their corresponding 3 & 4 way
connectors. Slide the short piece of the Woven Steel Cable over one end of each 3 & 4 way connector (The
cable should hang loosely until the second section is installed)
Align the predrilled holes so that the bolts can easily fit through. Bolt the pipe together using the
5/16” x 2 1/2” Bolts. Be sure that the flat part of the bolt is on top so that the cover fits flush to the frame. (If the
bolts are sticking up the bolt will puncture the cover). Once the centre frame work is fully connected assemble
the left and right sections. Connect Pipe “A” & “B” together, align and connect the pipe to the appropriate 3 &
4 way fittings. At this time finish installing the King Truss Cable system by slipping the end of the longer cable
over the 3 & 4 way fittings (on the left and right sections) and through the short cable hanging from the centre
fittings. (See Figure B)
Next connect Pipe E & F using the 5/16” x 1 1/2” bolt. Be sure the flat surface of the bolt is facing upward so
the end wall can slide across easily. Now connect the assembled E & F pipe to the pre-drilled holes at the two
ends (A pipe) using the 5/16” x 2 1/2” bolt. *(Again be sure that the flat surface of the bolt is facing the outside
so the cover sits flush against the frame.)
ROOF FRAME ASSEMBLY
REUSE
REDUCE
RECYCLE
Figure B