At this point the unit should be anchored to the ground. See anchoring instructions on page 9.
5/16”x2”
5/16”x2”
Insert Second
Step A
First connect pipes “A” & “A” and bolt them together with a 5/16” x 2 1/2” bolt. Place them next to each 3 & 4
way connector. Pick up one side of the unit by the bottom portion of the 4 way fitting. Lift one side and insert
the connected (“A” & “A”) pipe, making sure the wing nut faces towards the inside of canopy. Insert the centre
legs first and work outward. Repeat this step evenly until one side has all legs inserted. Repeat for the opposite
side. At this point lift each leg and insert the metal foot pad.
NOTE: The foot pads are NOT for anchoring the canopy!
Finish attaching the rest of the ball bungees to the frame and cover.
LEG ASSEMBLY
Step B
Next locate the horizontal pocket that runs the length of the unit. Slide pipe “C” & “D” into the pocket, section
by section. Attach by using the 3 way and 4 way clamps for the center legs. Use the 8 x 63.5mm bolt to secure
the clamps. (Be sure the flat portion of the bolt is flush against the cover) Be sure the cover is snug before
tightening the bar and clamps.
A
A
Insert First
REUSE
REDUCE
RECYCLE
2.6 m
8 f
t. 9 in.
4.1 m
13 ft. 7 in.
7.3 m
24 f
t.
5/16”x2 1/2”
