asseMblY
Warning!
IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE
SPINDLE SANDER IN UNTIL YOU HAVE REPLACED THE MISSING OR
DAMAGED PART. For your safety, complete the assembly of the Spindle Sander
before plugging it into the power supply.
MoUnting spindle sander to WorkbencH
For your safety, it is recommended to mount the Spindle Sander to a workpiece or
a fixed surface. This would avoid any chance of the Spindle sander from tipping
over during an operation. 4 mounting holes (A) Fig.3 are provided to mount Spin-
dle Sander to a workpiece. Mounting hardware is not included.
installing drUMs & sanding sleeVes on 1/2” spindle
1. Slide the large 2-3/4” washer (A) Fig.4 onto the 1/2” spindle (B) as shown.
note:
The drum and sanding sleeve size to use is determined by the work area of
your workpiece. For these instructions we will be installing the 2” drum and
sanding sleeve.
2. Slide the 2” diameter drum (A) Fig.5 onto the 1/2” spindle (B) until it contacts
the large 2-3/4” washer (A) Fig.4.
3. Slide the matching 2” sanding sleeve (C) Fig.5 over the 2” drum (A) until it
contacts the large 2-3/4” washer (A) Fig.4.
note:
No drum is used with the 1/2” sanding sleeve. If you desire to use the 1/2”
sanding sleeve, simply slide it onto the 1/2” spindle and secure it in place with the
washer, spring washer and hex. nut.
4. Position the matching washer(s) (D, E or F) Fig.5, and spring washer (G) over
the drum by siding it onto the 1/2” spindle.
Washers to use with drum/sleeve combo (Fig.5):
• 1/2” sleeve (no drum)- Use washer (D) Fig.5 and spring washer (G).
• 3/4” drum/sleeve- Use washer (E) Fig.5, washer (D) and spring washer (G).
• 1” drum/sleeve- Use washer (E) Fig.5, washer (D) and spring washer (G).
• 1-1/2” drum/sleeve- Use washer (E) Fig.5, washer (D) and spring washer (G).
• 2” drum/sleeve- Use washer (F) Fig.5, washer (D) and spring washer (G).
• 3” drum/sleeve- Use washer (F) Fig.5, washer (D) and spring washer (G).
5. Install the hex. nut (H) Fig.5 onto the 1/2” spindle. It is important to tighten the
hex. nut enough to compress the drum, this will make the drum expand and grip
the sanding sleeve. Hold the drum/sleeve combo while you tighten to prevent
the spindle from turning.
note:
When using the 1/2” sanding sleeve (without a drum), it is not necessary to
overly tighten the hex. nut. Tighten hex. nut just enough to prevent the sanding
sleeve from sliding upwards.
6. Once the drum/sleeve combo is properly installed as shown in Fig.6, slide the
matching table insert (A) Fig.6, position it in the recessed opening of the table
as shown.
FigUre 3
FigUre 4
FigUre 5
FigUre 6
