Technical Specifications
Model ......................................................................................................KC-1202LED-C
Voltage/Capacity ....................................................................................7.4V, 2,600 mAh
Battery type ....................................................................................................Lithium-ion
Lumens ....................................................................................................................1,200
Wattage ....................................................................................................................10W
Charger ....................................................................................................................120V
Charge time ..........................................................................................................3 hours
LED life ......................................................................................................+30,000 hours
WARNING
: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
WARNING:
Get to know your LED work light. Do not use until you have read and under-
stood this instruction manual. Only use the supplied King charger to charge the 7.4V
Lithium-ion batterie.
battery and Charger Safety Precautions
1) Never attempt to open the battery
for any reason. If battery housing has cracked,
discontinue use immediately and do not try to recharge it.
2) Never charge a wet LED work light
or if battery shows signs of corrosion.
3) Do not use an extension cord
with the charger, plug charger directly into a 120V AC
receptacle.
4) Do not use charger
if power its cord is damaged, replace damaged cord or charger.
5) Do not charge battery
when work area or the temperature is or below 0
0
C or above
45
0
C.
6) Unplug charger
when not in use.
7) The contents of the battery is slightly acidic
, do not incinerate the battery, it can
explode in a fire.
8) A small leakage from the battery
may occur under extreme usage, charging or
temperature conditions. This does not indicate a battery failure. However, if the battery
housing is cracked and leakage gets on your skin, follow these steps;
-Wash with soap immediately.
-Neutralize area with mild acid such as vinegar or lemon juice.
-If leakage gets into your eyes, flush with clean water for a minimum of 10 minutes, then
seek medical attention.
Lithium-ion battery
Lithium-ion batteries do not have a memory and do not require to be completely
discharged periodically. After use, charge battery so that it is fully charged for the next time
you use this tool. A fully charged battery will only loose about 2% of its charge per month
during storage.
LITHIUM bATTERY AND CHARGING
INFORMATION
GETTING TO kNOW YOUR
CORDLESS LED WORk LIGHT
Getting to know your CordlessLED Work Light
FIGURE 1
ASSEMbLY
ATTACHING WORk LIGHT HEAD TO bASE
Place the base (A) Fig.2 on a flat surface. Position
the U-Shape bracket (B) of the work light head onto
the base (A) as shown in Fig.2. Use the lock knob
(C), flat washer and spring washer to secure the
work light head on the base.
FIGURE 2
1- Carry handle with foam
2- Aluminum housing
3- 1 of 2 tilt lock knob
4- Pivot lock knob
5- Steel base
6- LEDs
7- Sealed On/Off switch
8- Light intensity controls
9- Input jack (charging)
10- 120V Charger adapter
