CONTACT SAFETY TRIP MECHANISM
OPERATING A CONTACT SAFETY TRIP TOOL:
• The operator is required to have the finger off the trigger and the nose of the stapler to be placed on
the workpiece.
• The contact safety trip mechanism is then depressed against the workpiece and the trigger is pulled
to drive the staple.
• The trigger is released after each staple is driven.
• Move the stapler to the next location and repeat the above procedure.
VERIFICATION
• Disconnect the air supply from the air inlet.
• Empty all staples from the magazine.
• Make sure the trigger and the contact safety trip mechanism moves up and down without sticking.
• Connect the air supply to the stapler air inlet.
• Depress the contact safety trip mechanism against the workpiece without pulling the trigger. The
stapler must not cycle.
Never use the tool if a cycle occurs.
• Hold the stapler clear of the workpiece. The contact safety trip mechanism should return to its
original down position. Pull the trigger. The tool must not cycle.
Never use the stapler if a cycle
occurs.
• Depress the contact safety trip mechanism against the workpiece and pull the trigger, the stapler
must cycle.
