OPERATION
USING YOUR 20V MAX LITHIUM-ION CORDLESS
RECIPROCATING SAW
WARNING:
Do not install battery until the accessory is
installed securely to the tool.
Wear protective gloves
and safety glasses,
an accessory can become extremely
hot during operation, danger of burns!
Charging the battery/battery level indicator
20V max Li-ion batteries come with a battery power level
indicator (A) Fig.2, press the button (B) to see the charge
level. If the battery level is low charge the battery. To
charge the battery (C) Fig.2, plug charger (D) power cord
into a 120V AC receptacle (do not use extension cord).
The red LED (F) will light up to indicate power to the
charger. Align the grooves the battery with those of the
charger and slide the battery all the way until it snaps into
place. The green LED (E) will flash indicating the
charging procedure has begun. Once the green LED (E)
stops flashing, the battery is fully charged and ready to
use. Press the battery clip (B) Fig.3 to remove battery
from charger.
Installing/removing battery from drill
To install a battery (A) Fig.3 to the base of the cordless
Reciprocating saw, align the grooves of the battery with
those of the saw base and slide the battery all the way
until the battery clip (B) snaps and holds the battery into
place.
To remove the battery from the base, press the battery
clip (B) Fig.3 and slide the battery away from the base.
Turning Tool On/Off
To turn your Reciprocating Saw
ON
, depress and hold
the safety button (A) Fig.4, then depress the trigger (B).
Release trigger to turn your saw
OFF
.
Variable speed trigger
Your cordless Reciprocating Saw is equipped with a
variable speed trigger (B) Fig.4. The speed can be controled from the minimum to the
maximum strokes/min just by the pressure applied to the trigger. Apply more pressure to
increase speed and apply less pressure to decrease speed. Release trigger to stop saw.
Figure 2
Figure 3
Figure 4
