Thank you for purchasing this Kinetik Labs product. Please be careful when using electronic equipment and read any safety
information supplied with it.
www.kinetiklabs.com
Introduction
Description
© Copyright AWE Europe Ltd 2010. All rights reserved. Design and specifications are subject to change without prior notice. No part of this document may be reproduced, for any
purpose, without prior written permission from AWE Europe Ltd. AWE Europe Ltd is not liable for omissions or for technical or editorial errors herein or for damages directly or indirectly
resulting from the use of this Kinetik Labs product. ‘Kinetik Labs’ and the ‘Kinetik’ logo are trademarks of AWE Europe Ltd. Made in Taiwan for Kinetik Labs
1.
Apply the stick pad to the base of the
receiver and place it in the desired location
with the rounded surface pointing into the
room. Be sure to position it in clear line of
sight of where the remote controls will be
pointing.
2.
Plug the IR receiver jack securely into
the Kinetik connection block input
indicated ‘IR Receiver’.
Once powered the IR receiver will blink
when receiving IR signals.
Additional components are available
separately.
The KLIR-CB1 connection block (available separately) comes
with a Phoenix connector. This can be used as an alternative
input for IR receivers or for attaching additional receivers to
the system. To attach additional Kinetik IR receivers, you will
need to remove its 3.5mm jack plug to wire into the connec-
tion block (as shown).
Instructions / System Wiring Diagram
Wired connection
Contents
AV equipment
cupboard / room
CD
Play
er
Mo
del n
umb
er
CD
Play
er
Mo
del n
umb
er
Amp
lifier
Mo
del n
umb
er
CD Player
DVD Player
Amplifier
Emitters
Power supply
Connection block
Zone 1 (Lounge)
IR Receiver
Dimensions / Specification
™
Kinetik Labs
KLIR-SMR1
Surface Mount IR Receiver
The KLIR-SMR1 is a surface mount Infra Red (IR) receiver. It is designed to pick up IR signals from remote controls as part
of an IR control system. The IR receiver can be surface mounted for optimal and versatile positioning (on a TV bezel for
example).
Solid line
Black
Striped
12V DC
Ground
IR
:
:
:
It is possible to connect and power up to 3 Kinetik
IR receivers simultaneously
IR
G
V+
WIRING
Cable extension
The IR receiver cable can be extended to custom lengths of up to 300m. It is recommended that two strands of CAT5 are
used per signal.
To do this, firstly you need to determine the length of the run and cut that amount. Now cut the receiver cable and use the
CAT5 to extend the cable length.
You must ensure you connect the identical cores as this may potentially damage the components and the system will not
work.
It is not necessary to use the receiver’s jack termination when you have cut the cable. You can instead use the connection
block’s black Phoenix connector (see ‘Wired Connection’).
IR frequency bandwidth:
38kHz +/- 2kHz
Control range:
15m (6m in direct sunlight)
Reception angle:
+/- 45 degrees
Max. number of IR receivers on system:
3
Max. cable length:
300m
x1
KLIR-SMR1
Surface mount receiver
x1
Receiver double-sided stick pad
10mm
10mm
65mm
14mm
3.5mm
Cable length: 2000mm (2m)
KLIR-SMR1 Surface Mount Receiver
SIDE
END
