Installation Instructions
1.
3.
4.
2.
Using the cut out template, draw a
250mm circle on the ceiling / wall,
where you wish to install the speaker.
Be careful when handling the speaker. It is okay to hold using the tweeter
pole but do not touch the drive unit as it could result in damage.
Cut out a hole using a suitable saw or
hole cutting tool.
Now pull through the speaker cable
and connect it to the speaker binding
posts located on the rear of the
speaker.
To do this, press down on each binding
post and feed the bare cable wire into
the hole. Releasing the binding post
will lock the wire in place.
You will find the impedance switch next
to the binding posts. Set this to the
impedance you require.
Consult your amplifier manual
5
Ensure there are no joists in the
way.
Be careful not to cut through wiring
or pipes.
Make sure you connect the
speaker cable to the correspond-
ing + / - outputs from the amplifier.
