background image

1.800.321.5022  

www.KineticoPRO.com 

[email protected]              

OPERATING 

GUIDE

STEP #4 Install SANI Cartridge(s)

 

a.

 Generously apply lubricant to all three O-rings and install  

  SANI cartridge(s) into the filter manifold by aligning the  
  tabs on the filter with the notches on the manifold 

 and  

  push upward to insert filter. 

CAUTION: Filter may be heavy.

 

For KPMF/SMF filters:

 Turn cartridge clockwise (as viewed  

  from bottom), until a definite stop is felt and filter is seated. 
 

For HPF filters: 

Turn the cartridge counterclockwise (as viewed  

  from bottom), until a definite stop is felt and filter is seated.

STEP #5 System Flush

a. 

Slowly open inlet valve on manifold. 

b.

 Open downstream water lines and taps one at a time.

  Keep ONE tap open until you smell or detect sanitizing/ 
  descaling agent then close the tap.

c.

 Repeat step 5b for all downstream lines/taps, one at a time.

NOTE: IF you open a filtered water line and DO NOT detect
sanitizing/descaling agent return to step 3 and add additional
agent to cartridge(s) per your instructions.

STEP #6 System Flush Completion

a.

 After time specified for your sanitizing/descaling agent,  

  open all the filtered taps you introduced the sanitizing/descaling  
  agent into and flush for at least 5 minutes. Once complete,  
  close all taps.

b.

 Shut off inlet valve to manifold and depressurize filtration  

  system prior to removing the SANI cartridge(s)  
  (reference step 1). 

NOTE: The SANI cartridge(s) should be drained and thoroughly rinsed prior to storage or disposal.

STEP 7: Install NEW Water Filters

a.

 Remove and discard sanitary cap from top of new filter. Generously lubricate O-ring.

b. 

Align tabs on filter with notches in manifold. 

 Push upward to insert filter. 

For KPMF/SMF filters:

 Turn filter clockwise (as viewed from bottom), until a definite stop is felt and  

filter is seated.

For HPF filters:

 Turn filter counterclockwise (as viewed from bottom), until a definite stop is felt and  

filter is seated.

c. 

Slowly open inlet valve on manifold. Open the flush valve(s) and flush system for 5 minutes.  

  Close the flush valve(s). Now your water filtration system is ready for use.

Change out filter annually or when capacity has been reached.

If you have any questions, please call technical support at 1-800-321-5022.

©2022 Kinetico Incorporated. All Rights Reserved. 

Kinetico Incorporated. 3980 Lakefield Ct. Suwanee, GA 30024 

Made in U.S.A. Operating Guide_02-22

803-038

Figure 1

Figure 5

Two small  

black O-rings 

Outside  

black  

O-ring

Reviews: