www.kurtkinetic.com | 1.877.226.7824
Page 2
COMPONENTS
Part A
Folding
Frame
Tools Required for Assembly: 14mm Wrench, 4mm Hex Key
When unpacking, check that the following components are present:
Part B
Resistance
Unit
Your Kinetic Trainer is designed for use with road, mountain, BMX and
recumbent bikes. Before adjusting these legs, you must know your
bike’s tire size, which is printed on the sidewall of every tire.
When shipped from the factory, the folding leg is mounted in Position
1 on the main frame and will function with all tire sizes. However, to
lower the drive wheel and maintain good riding position it is best to
adjust the leg position to match your tire size. Ideally, your rear tire
should be approximately 1-1/2” from the floor. Use the chart shown
here to determine the recommended leg position.
The appropriate leg position may vary for some wheel diameters
because of tire thickness. Choose the setting that positions the bike as
level as possible.
Part C
L-Bolt
Part F
Mounting
Bolt and
Nut
Part E
Adjustment
Knob and
Washer
Part M
Skewer
Part D
Spring
ADJUSTABLE FOLDING LEGS
1
2
4
3
PLEASE NOTE:
If any of the
components
listed are
missing, please
call our Customer
Service hotline at
877-226-7824.
Part B
Resistance
Unit
ROLLER
FLY
WHEELS
YOKE
Because we
test each
trainer there
will be tire
marks on the
roller.
SERIAL
NUMBER
Part N
Small Cone
Cup
(Installed on trainer)
Part K
Small Cone Cup
Skewer Adapter
(see www.kurtkinetic.com for installation instructions)
FRAME
POSITION
position 1
position 2
position 3
position 4
MAXIMUN
TIRE SIZE
700c / 29”
650c
24”
20”
Use two wrenches to remove the nut.
Remove bolt. Select appropriate hole
and reinsert bolt through frame and leg.
Attach nut and tighten securely until
some resistance is felt in the movement
of the folding leg. Repeat with other side.
