Kinetic Solar K-Rack™
Installation guide
Page 30 of 37
27 May 2019
9.3.
L-Brackets / Rails
a)
Insert the K-Nut of the L-Bracket assembly into the side channel of the rail.
*See section 5.3.1
b)
Attach the short end of the L-Bracket to the base plate using the supplied flange
nut. The long end should be upright.
9.4.
Rail Joiners
*If not using Rail Joiners, continue to section 9.5.
a)
Insert the Joiner assembly into the side channel of the rail at the ends being
joined. Ensure Joiner is centered between the two rail ends.
b)
Tighten the bolts of the Joiner. Torque to 12 ft-lbs (16.3 N-m).
9.5.
Micro Inverters
*Install Micro Inverters according to manufacturer specifications. The following
attachment methods can be used.
Figure 31 Installed Rails
