Kinetec Maestra Series, User Manual

Page: 13 / 28

Kinetec Maestra™
EN
12 / 26
12.8.2. Using Programs
The device Kinetec Maestra™ allows you to store up to 16 programs (numbered 1 to 16), including the type
of movement, ROM, speed, load, pauses and timer.
The original parameter values of the program are empty. These values can be modified and saved at any
time (see ‘To enter a program’, page 11)
Beginning
Keys to
press
Display Remarks
To stop the unit
PRONO/SUPINATION
-10 STOP 5 10
Check that the hand control is not
locked (See page 8).
To access program mode
WRIST EXT/FLX
-30 PRG no.2 30
The program number blinks.
To change the program if necessary
or
THUMB OPPOSITION
0 PRG no.5 30
The new program number blinks.
To exit and confirm the selected program
THUMB OPPOSITION
0 STOP 10 30
The current parameters are those
recorded in program 5.
To exit without confirming the selected
program
PRONO/SUPINATION
-10 STOP 5 10
Back to the starting parameters.
To start the unit
THUMB OPPOSITION
0 RUN 20 30
The angle display changes with the
current movement.
Warning : Always check the motion parameters displayed on the hand control before starting the device.
12.8.3. Reading the values of a program: e.g. SPEED
Beginning
Keys to
press
Display Remarks
To stop the unit
WRIST EXT/FLX
25 STOP 20 90
Check that the hand control is not
locked (See page 8).
To access program mode
PRONO/SUPINATION
-10 PRG no.4 10
The program number blinks.
To change the program if necessary
or
THUMB OPPOSITION
0 PRG no.3 50
The new program number blinks.
To read the speed value
THUMB OPPOSITION
SPEED: 2
Displays the speed value.
After 15 seconds or after pressing on another
key
WRIST EXT/FLX
25 STOP 20 90
To exit and confirm the selected program
THUMB OPPOSITION
0 STOP 20 50
The current parameters are those
recorded in program 3.
To start the unit
THUMB OPPOSITION
0 RUN 20 50
The angle display changes with the
current movement.
Comments:
‡7KHYDOXHVVKRZQLQWKH¶'LVSOD\·FROXPQDUHH[DPSOHV7KH\DFWXDOO\ depend on the stored programs.
‡7KHFXUUHQWPRYHPHQWSDUDPHWHUVFDQEHFKDQJHGZKLOHXVLQJWKDWSURJUDPEXWQRGDWDZLOOEHVWRUHGLQ
the original program. See Program Mode (page 11) to modify programs.
Comments
:
‡:KHQDSURJUDPKDVEHHQGHOHWHGWKHGLVSOD\VKRZV
Program 11
E MP T Y