LEDs
The blue LEDs in the upper right corner of the right keying module include four lights: caps lock, numlock (PC), scroll
lock (PC), and fn/sleep. Numlk (numlock) and scrlk (scroll lock) are PC status indicators that are not active on your
Mac. The fn LED indicates when the embedded layer has been activated with the fn key. The Fn LED is also
illuminated when the computer is in sleep mode.
USB 2.0 ports
Two bus-powered USB 2.0 ports located at the back of the right keying module enable connection of a mouse or
flash drive, or a self-powered digital camera or printer.
Note: these ports provide a maximum of 400 mA and
therefore cannot be used to charge a digital device such as an iPod or iPhone.
Physical configurations
(removing pivot tether)
The Freestyle2 convertible keyboard is shipped with the two keying modules connected by a
linking cable
and by a
removable
pivot tether™
(shown at right). To remove the pivot tether, slide the appropriate
release button
towards the
outside of the keyboard and allow the pivot tether to detach from that keying module. The two keying modules may then
be separated by up to 9 inches with the standard separation model (KB800HMB-us) or by 20 inches with the
KB800HMB-us-20 model. Other physical configurations are possible with optional accessories (see below). To purchase
accessories, inquire with your dealer or visit kinesis.com.
Optional accessories
For product details & instructional videos, visit www.kinesis.com, select “keyboards” and navigate to the Freestyle2 page.
VIP3
™
Accessory Kit, AC820-blk.
V-lifters with integrated palm supports provide three angles of adjustable tenting (5
○
, 10
○
,
and 15
○
, instant and sturdy!). These V-lifters must be used with the included palm supports.
V3
™
Accessory Kit, AC730-blk.
These three-angle V-lifters provide instantly-adjustable and sturdy tenting (5
○
, 10
○
, and 15
○
)
without palm supports. The V3 V-lifters do not require and will not work with Freestyle2 palm supports.
Ascent
™
Accessory Kit, AC740-blk.
Sturdy and incredibly versatile steel modules support adjustable tenting at 10
○
increments over a wide range of angles (20-90 degrees). Each side may be tented differently. A rigid steel linking plate may be
attached for fixed separation. Freely adjust splay or completely separate the two sides. Optional Freestyle2 palm supports work
at lower tenting angles.
Freestyle2 palm supports, AC806PS-blk.
These are included with AC820-blk but may be ordered separately to use with
KB800PB or with AC740-blk. Includes gel-like, self adhesive, replaceable palm pads (covered with black lycra). Replacement
palm pads (
AC700PP-blk
) may be purchased separately.
Warranty
A two-year warranty applies to the original purchaser of the Freestyle keyboard and accessories. For details visit www.kinesis.com and click
on the “support” link to find PDF copies of User Manuals.
Technical Support
Contact Kinesis Technical Support by email ([email protected]) or by phone (USA 425-402-8100). Staff is on hand 8:00am to 4:30pm
Pacific time, M-F. Please be prepared to provide the serial number of your keyboard, your purchase date, the computer model, and the
operating system of your computer, as well as the details of your question or problem.
Regulatory and legal information
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
Warning: To assure continued FCC compliance, the user must use only shielded interfacing cables when connecting to computer or peripheral. Also, any
unauthorized changes or modifications to this equipment would void the users authority to operate.
INDUSTRY CANADA COMPLIANCE STATEMENT
This Class B digital apparatus meets all requirements of the Canadian interference-causing equipment regulations. Cet appareil numérique de la classe B
respecte toutes les exigences du règlement sur le matérial broilleur du Canada.
Disposal of WEEE in the EU
To ensure that electronic equipment is recycled in a manner that protects human health and the environment, it is the user’s responsibility to dispose of
it by delivering to a collection point designated for recycling electrical and electronic waste equipment, For more information please contact your local
city office, your household waste disposal service, or the seller from whom you purchased the product.
Trademarks and patents
Kinesis and Freestyle are registered trademarks and Freestyle2, Pivot Tether, VIP3, V3, Ascent, and Kinesis Computer Ergonomics are trademarks of Kinesis
Corporation. Mac and Mission Control are registered trademarks of Apple Inc. The Freestyle2 keyboard and accessory designs are protected under US patents
7,828,489, 8,289,684, 8,454,254 and RE43,485. Other patents pending.
Pivot Tether
numlk
(pc)
caps
lock
scrlk
(pc)
fn
fn
sleep
Kinesis Corporation
22030
20
th
Avenue SE, Suite 102
Bothell, WA 98021 USA
Version 8-27-13
www.kinesis.com [email protected] phone: 800-454-6374 (USA only) or 425-402-8100 (fax 425-402-8181)
LEDs
