14
Assembly and operating instructions
_SpeechPoint
3
5.3 Installation of additional media technology
Attention
:
The installation of media technology components must be carried out by trained and instructed personnel!
Basically, electrical components are permanently installed in the lectern.
Connect the devices to the power supply (socket strip in the console) or connect them to other devices with appropriate control
and signal lines.
1. Move the lectern to the uppermost position.
2. Then disconnect the power supply from the mains (pull out the mains plug).
3. For optimum access, open the two inspection accesses at the rear and the desk plate at the top. (key included in the scope of
delivery)
4. Install all desired components such as displays, media controls, amplifiers, etc. The total power must not exceed 2500W!
5. Then check all cables for correct fit. No cable or component may be damaged by moving the console!
6. Reconnect the console to the power supply.
7. Move the console all the way down. Check the interior for possible damage to the installed components and cables during
the downward movement and repair if necessary.
8. When the installation is complete, close the inspection doors again.
9. The console is now ready for operation.
