SPILLAGE MONITORING SYSTEM
This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue.
If this system operates the fire will go out. If this occurs, leave the fire for at least
three minutes then follow the lighting procedure as described in the previous sec-
tion.
In the event of repeated operation a CORGI registered gas installer
must be called to investigate and rectify the cause.
CLEANING - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool.
CLEANING THE BLACK MAGIC TRIM
The Black Magic trim that was supplied with this fire should only be cleaned using
a clean, damp cloth. The trim is best cleaned by removing it from the fire and
placing it face up on a flat surface. The trim is easily replaced by repositioning it
on the fire and pushing it back onto the magnets.
Abrasive cleaners, chemical cleaning agents or any type of polish must
never be used as damage to the finish may result.
CLEANING THE FUEL BED
We do not recommend cleaning of coals or fuelbed components as these are
fragile and damage may result.
None of these parts must be washed or
exposed to any cleaning agents or water
.
Any damaged parts must be replaced by contacting your dealer. Coals must only
be replaced with a complete and genuine replacement set and the fire must never
be run with the wrong number or damaged coals. The fuelbed must be carefully
re-assembled as stated in the following section.
5
Note : Prior to replacing the oxypilot on this product due to
suspected failure of the component, please remove all debris that has
collected on the lint guard of the oxypilot itself.
