kincrome KP8001, Manual

Page: 8 / 12

7
BATTERYLESS JUMP STARTER
3. Bypass Operation
Note: If the Vehicle’s battery is too flat to initiate the vehicles ECU, the LCD Control Panel Display (3) will show Fig 8
when using the weak/flat battery, please resort to Bypass Mode using the following steps.
1. Pre-Charge the Batteryless Jump Starter using a method as advised in
Operation 2.1 (Page 6).
2. Connect the Batteryless Jump Starter to the vehicle as shown in (Fig. 13).
Disconnect the positive cable terminal from the vehicle’s battery. Attach
the Positive Battery Clamp RED (1) of the Batteryless Jump Starter to
the positive battery lead terminal of the car. ENSURE that the battery
lead can be reconnected to the battery WITH the Batteryless Jump Starter clamp still attached. (Ensure that
the battery terminal hole is not obstructed by the Positive Battery Clamp RED (1).
3. Attach the Negative Battery Clamp BLACK (2) to the negative battery terminal (or relevant negative jump
starter connection point of your vehicle)
WARNING! Ensure the Positive Battery Clamp RED (1) or vehicles
battery lead terminal does not come in contact with the vehicles body
or other metal components in the engine bay.
4. Press the ON / OFF Button (6) for approx. 2-4 seconds to activate the
Bypass Mode.
5. Start the vehicles engine.
6. As soon as the engine starts, reconnect the joined positive leads to
the positive battery terminal (Fig 14). Once on the battery terminal,
disconnect the Positive Battery Clamp RED (1) from the positive
battery lead (Fig 15).
7. Tighten the vehicles’ positive battery terminal securely.
Note: It may take up to an hour to fully charge the in vehicle flat battery
using the vehicles alternator.
•
It is suggested that you have your vehicles’ battery and charging
system checked by a mechanic or auto electrician to ensure that your vehicles charging system is functioning
correctly, or if you suspect the battery is becoming unreliable. (any such costs associated with seeking advice
from an automotive repairer is not covered by Kincrome).
• Or recharge your vehicles battery using the KP8001 / KP8002 Battery Charging Function or a battery charger
compatible with your batteries ratings. Refer to the battery chargers output rating details to ensure it is
suitable for use on your battery.
Note: KP8001 & KP8002 Battery Charger Function is shown on Page 8.
WARNING! DO NOT leave the vehicles’ engine running with the Batteryless Jump Starter connected to the battery
after jump starting the vehicle.
1. Connection - for starting the engine.
Jumpstarter clamp joined to the positive
cable terminal.
2. After Jump Start- engine has started
replace the joined clamps onto the battery
3. Disconnection- With engine running and
positive cable re-connected, remove both
jump starter clamps.
RED RED
RED
BLACK
BLACK
BLACK
1. Connection - for starting the engine.
Jumpstarter clamp joined to the positive
cable terminal.
2. After Jump Start- engine has started
replace the joined clamps onto the battery
3. Disconnection- With engine running and
positive cable re-connected, remove both
jump starter clamps.
RED RED
RED
BLACK
BLACK
BLACK
1. Connection - for starting the engine.
Jumpstarter clamp joined to the positive
cable terminal.
2. After Jump Start- engine has started
replace the joined clamps onto the battery
3. Disconnection- With engine running and
positive cable re-connected, remove both
jump starter clamps.
RED
RED
RED
BLACK
BLACK
BLACK
Fig 13
Fig 14
Fig 15