Push up the
right grey release lever
Pull down the
left grey release lever
2
• Periodically tighten all hardware
• Periodically lubricate castors
• Lubricate the slides twice a year
• Lubricate the lock with graphite annually
• Use a damp Microfibre cloth to clean all surfaces
Assembly Instructions
Maintenance
2
Chest & Trolley Combo
9 Drawer
K7529
1
2
3
4
5
6
7
8
9
10
11
11
10
REMOVE PRODUCT FROM CARTON AND STAND UNIT UPRIGHT
UNLOCK THE TROLLEY AND REMOVE THE HANDLE, CASTORS AND
SIDE PARTS TRAY FROM THE DEEP DRAWER
LOCK UNIT, THEN FLIP UNIT UPSIDE DOWN
UNLOCK CABINET, THEN OPEN CABINET DOORS. LOCATED INSIDE
IS THE CHEST, AND 4 BOLTS SECURING IT ON A WOOD PANEL
These are holding the chest down and need to be removed using a
12mm Spanner or 5mm Hex Key.
NOTE: Bolts need to be kept for castor installation further in the
process.
REMOVE THE REMOVEABLE PANEL FROM THE REAR OF THE
TROLLEY USING A PHILLIPS SCREWDRIVER
.
Unscrew the 8 screws from the removeable panel. Save the screws
to reinstall the panel later. There are 4 short screws and 4 long
screws that come out. Ensure they go back in the same place.
NOTE: Short Screws at the bottom of the Panel, and longer screws
at the top.
REMOVE THE CHEST FROM THE TROLLEY FROM THE
REMOVEABLE PANEL ACCESS
WITH THE UNIT STILL UPSIDE DOWN, REINSTALL THE BACK
PANEL AND SCREWS, WITH SHORT SCREWS AT THE TOP, AND
LONGER SCREWS AT THE BOTTOM
Please refer to pictures in Step 5.
MOUNT THE CASTORS TO TROLLEY.
Ensure both Lockable Swivel Castors are located at the front of the
trolley for easy locking when in use, and tighten using a 12mm
Spanner or 5mm Hex Key.
LOCK UNIT, AND FLIP TO THE CORRECT ORIENTATION.
STANDING THE TROLLEY UPRIGHT, INSTALL THE CHEST ON TOP
OF THE TROLLEY.
INSTALL THE SIDE HANDLE AND SIDE PARTS TRAY TOGETHER.
First, place the Handle in position and hold the Side Parts Tray in
place whilst the second person screws in the bolts. This can be done
on either left or right side of the trolley and will need a 10mm
Spanner to tighten.
REMOVING THE DRAWERS
Fully extend the empty drawer. Push up the right grey release lever
while pushing down the left grey release lever. Pull the drawer
outward until it is released from the drawer slide.
RE-INSERTING THE DRAWERS
Extend the drawer slides. Insert the brackets on each side of the
drawer into the slots on the slides, being careful that they are
properly positioned. Once properly inserted, completely close the
drawer to set the slides in their proper positions.
1
3
5
6
8
Small Screw on Left,
Long Screw on Right
A
A
A
B
C
B
B
C
Short Screws at the bottom of
the Panel, and longer screws at
the top.
K7529 manual.indd 2
2/05/2018 10:24 AM
