kincrome K13271, Manual

Page: 5 / 10

4
INDUSTRIAL AIR HYDRAULIC RIVETER
7) Description of Symbols
The following symbols could be shown on the tool:
Read the instruction manual before use. Risk of Explosion
Wear Ear Protection Wear Eye Protection
CFM
Cubic Feet per Minute flow
SCFM
Cubic Feet per Minute flow at
standard conditions
PSI
Pounds per square inch of pressure
NPT
National pipe thread, tapered
Nm
Newton meters of force
BSP
British standard pipe
8) Assembly
Connecting the Air Supply to the Air Hydraulic Riveter
1.
Wrap teflon tape (not supplied) around the Nitto Style Fitting (11) approximately 4 to 5 times to ensure a leak free seal.
2. Screw in Nitto Style Fitting (11) to the Air Inlet (1) of the Air Hydraulic Riveter.
3. Using a 14mm spanner (not supplied) fasten the Nitto Style Fitting (11).
4. Pull back the female coupler on your air hose, and feed over the Nitto Style Fitting (11).
5. Release the female coupler on your air hose. You should now have a leak free, air supply to your tool.
Assembling the Frame Cap (6)
1.
Secure the Frame Cap (6) Firmly to the Air Hydraulic Riveter by feeding the Frame Cap Nut (5) over the Frame Cap (6).
2. Continue by catching the thread of the Frame Cap Nut (5) to the Air Hydraulic Riveter and rotate clockwise. Ensure that the slot
on the Frame Cap (6) is facing upward to avoid spilling used Rivet pins.
Changing Air Hydraulic Riveter Nose Pieces (3)
Note: Different size Nose Pieces require different Jaw assemblies. The supplied tools are for maintenance only. Please use a 17mm
(for rear jaw case) & 19mm (for front jaw case) Spanners (not supplied) when loosening the jaw cases for the first time.
(For 6.4mm, 5.6mm, 4.8mm & 4.0mm Rivets use 13a, 13b & 13c)
(For 3.2mm, 2.4mm Rivets use 12a, 12b & 12c)
Note: Add anti-seize on thread of Rear Jaw Case (14).
1.
Remove the nose piece with the supplied Riveter Nose Piece Spanner (9b) by rotating anticlockwise.
2. With the supplied Riveter Ring Spanner (9a) remove the frame head by rotating anticlockwise.
3. Using the supplied Jaw Spanner (10) to hold the grove of the Rear Jaw Case (14). Then use the Riveter Spanner (9c) to loosen
the front Jaw Case (13a) by rotating anticlockwise.
4. Remove the Large Front Jaw Case (13a) which houses the Large Jaws (13b) and Large Jaw Pusher (13c).
5. Gather the Small Front Jaw Case (12a) and drop the Small Jaws (12b), followed by the Small Jaw Pusher (12c) into the Small
Front Jaw Case (12a).
6. Thread the small Front Jaw Case (12a) to the Rear Jaw Case (14). Using the supplied Jaw Spanner (10) to hold the grove of the
Rear Jaw Case (14). Then use the Riveter Spanner (9c) to tighten the front Jaw Case (13a) by rotating clockwise.
DO NOT OVERTIGHTEN.
Note: If the front Jaw Cases (12a or 13a) do not assemble correctly, then the Jaw Pusher (12c or 13c) has not aligned with the spring,
remove and retry.
7.
Reinstall the Frame Head (4) and desired Nose Piece (3) using the supplied tools.
8. Repeat above instructions when assembling Large Jaws (13a, b & c).