IMPORTANT SAFETY INFORMATION
The use of a Hydraulic Press has inherent dangers to avoid risk of personal injury or property damage
make sure you are fully aware of the operating instructions for this product, the recommendations in this
manual can not cover all eventualities this press is designed and intended for use by properly trained and
experienced personnel. If you are not familiar with the proper and safe operation of a hydraulic press, do not
use until proper training and knowledge has been obtained.
. Do not exceed working load limit of this press. This Press is intended for pressing, bending, and
straightening purposes only. Do not use for any other purpose except those listed in this manual, never use
to compress springs or other objects that could be ejected from the press. Do not compress objects that
could shatter.
UNPACKING AND ASSEMBLING HYDRAULIC PRESS
Unpacking Carton
Place carton in a clear, open area such as garage floor. Remove pieces from carton, caution this press is
heavy please do not attempt assembly on your own seek appropriate assistance.
Assembly
Press frame #1 is positioned upside down and
held vertical.
Attach leg #11 to one side of press. Attach
opposite Leg #11 Turn press over and stand
on legs
– ensure press is stable before
proceeding with assembly.
Attach cylinder #20 to the fixed plate #2.
Locate cylinder clamp #4 and attach firmly.
Attach hand pump #16 to side of press. With
hose outlet facing down. Connect hydraulic
hose to cylinder.
(Attaching pump with hose
outlet at top will reduce capacity of press and
accuracy of gauge)
Insert working table #6 at an angle and then
raise to parallel. Hold in place with #5
positioning rods.
Place arbor plates #7 on working table
