IMPORTANT SAFETY INFORMATION
The use of a transmission jack has inherent dangers to avoid risk of personal injury or property damage make
sure you are fully aware of the operating instructions for this product, the recommendations in the vehicle
owners manual prior to using this tool. Do not exceed maximum lifting capacity of 500 kg. This
Transmission jack is intended for automotive use only. Be aware that large or heavy transmissions may
exceed the stated capacity check vehicle owners manual or contact the transmission manufacturer. Do not
use for any other purpose accept the raising and lower of transmission, gear boxes, or differentials. Never
use to raise a vehicle, structure or building, do not lift any human load and never ride on the Transmission
jack.
UNPACKING AND ASSEMBLING JACK
Unpacking Carton
Place carton in a clear, open area such as garage floor. Remove jack and handle from carton.
Handle - Handle Wrench
With the jack sitting on its wheels on a flat surface, place
handle wrench over release valve. Turn handle slowly
clockwise until firm DO NOT over tighten. Remove handle
from release valve and slide handle into handle sleeve.
Testing Handle Operation
Briefly test jack operation as follows BEFORE using to lift any load. With handle on the release valve turning
clockwise or counter clock wise allows jack to be raised and lowered. To raise jack, twist handle completely
clockwise until it stops. Do not force or tighten beyond this point. Take handle from release valve and
place in handle sleeve, Pump handle a few times to raise jack about halfway. If jack does not begin to rise
after a few pumps, check to make sure the release valve is tight. With jack raised, place handle on release
valve twist handle slowly counterclockwise to lower jack. A normal hissing sound may be heard as jack
lowers and pressure in hydraulic cylinder is released.
