IMPORTANT SAFETY INFORMATION
The use of a vehicle jack has inherent dangers to avoid risk of personal injury or property damage make sure
you are fully aware of the operating instructions for this product, the recommendations in the vehicle owners
manual for jacking of your vehicle prior to lifting the vehicle. Do not exceed maximum lifting capacity of this
jack. This jack is intended for automotive use only. Be aware that large or heavy vehicles may exceed
jack’s stated capacity check vehicle owners manual or contact the vehicle manufacturer. Do not use for any
other purpose except the raising and lower of vehicles, Never use to raise any structure or building, Do not lift
any human load and never ride on jack.
UNPACKING AND ASSEMBLING JACK
Unpacking Carton
Place carton in a clear, open area such as garage floor. Remove jack and handle from carton. Assemble
handle by inserting into pre cut grooves and twist to lock in place.
Handle - Handle Wrench
With the jack sitting on its base on a flat surface, place
handle wrench over release valve. Turn handle slowly
clockwise until firm DO NOT over tighten. Remove handle
from release valve and slide handle into handle operating
lever.
Testing Handle Operation
Briefly test jack operation as follows BEFORE using to lift any load. With handle on the release valve turning
clockwise or counter clock wise allows jack to be raised and lowered. To raise jack, twist handle completely
clockwise until it stops. Do not force or tighten beyond this point. Take handle from release valve and
place in handle operating lever, Pump handle a few times to raise jack about halfway. If jack does not begin
to rise after a few pumps, check to make sure the release valve is tight. With jack raised, place handle on
release valve twist handle slowly counterclockwise to lower jack. A normal hissing sound may be heard as
jack lowers and pressure in hydraulic cylinder is released.
