www.kimray.com
SG:_CV003
Issued 2/22
ROTARY TO LINEAR ADAPTER
QUICK START GUIDE
WARNING
A leaking valve is an indication that
service is required. Failure to take valve
out of service immediately may cause a
hazardous condition.
WARNING
Before any service, be certain that
the valve is fully isolated and that all
pressure upstream and downstream has
been relieved. Use bypass valves or
fully shut off the process.
Be sure that any operating or instrument
gas lines have been disconnected.
Never stand directly in front of or over a
valve when the system is pressurized.
The valve could suddenly open, blowing
debris into the person’s face and eyes.
NOTE
If conditions indicate the possibility of
backward flow you may wish to install
check valves.
Never assume that a check valve is fully
blocking the downstream line.
WARNING
Before beginning installation:
• Read and follow instructions.
• Make sure the valve cannot operate
during installation.
Do not exceed the maximum supply
pressure specified on the valve name
-
plate.
Never tighten any fitting or the main
connections to the valve while there is
pressure on the line.
For questions or comments, contact your local Kimray authorized distributor, or visit www.kimray.com.
Kimray Inc.
Customer Service: 405.525.6601 | [email protected]
52 NW 42nd Street
Oklahoma City, OK 73118
Product/Tech Support: 405.525.4264 | [email protected]
Maintenance
For maintenance of the High Pressure Control
Valve, please reference page SG:CV001.
For maintenance of the Electric Actuator, please
follow the manufacturer’s maintenance schedule
and recommendations.
For maintenance of the R2L adapter, inspect
the coupling block bolts and flange adapter lock
nuts on a routine basis to ensure they are tight.
Disassembly of the R2L adapter is not suggested.
For repair, please contact your local Kimray
authorized distributor.
Start-up and Test
Warning:
Before any service, be certain that the valve is
fully isolated and that all pressure upstream and
downstream has been relieved. Use bypass
valves or fully shut off the process. Be sure that
any operating or instrument gas lines have been
disconnected. Never assume that a check valve is
fully blocking the downstream line. Never tighten
any fitting or the main connections to the regulator
while there is pressure on the line. A leaking valve
indicates that service is required. Failure to take
the valve out of service immediately may create a
hazardous condition.
Verify all pressure connections are tight before
pressurizing the system.
Only use genuine Kimray replacement parts.
Repair kits are available. See Section 1
(Series CV) of the Kimray catalog for the
correct repair kit numbers.
Visit www.kimray.com or contact your
Kimray authorized distributor for additional
product information and / or literature.
