Kimberly-Clark Suretouch, Installation Instructions Manual, Page: 4 / 19

6 7
Snap 1 Snap 2
22. Push the battery compartment cover onto the
battery compartment base until both the top
and bottom of the cover snap into place (see
figure 21).
Note: The batteries are already loaded in the
battery compartment cover.
23. Install the assembled battery
compartment to the back or side wall
under the countertop using screws
(included) or double sided tape (not
included). Position it no further than 32”
from the motor module (see figure 22).
Note: The red and yellow lights on the
bottom of the soap discharge head should
begin to blink, indicating proper installation.
If the lights do not flash, refer to the
Troubleshooting Guide.
Fig. 28
Fig. 26
Fig. 27
Soap Refill Bottle Installation and Removal
Fig. 29
2
1 1
24. Install the power cable plug into the
power receptacle on the motor module
(see figure 23).
Note: To change batteries, push the key
fully into the top of the assembled battery
compartment (see figure 24) then grip the
battery compartment cover and pull it away
from the battery compartment base (see
figure 25). Load new batteries and the repeat
step 22.
1. Slip the straw into the underside of the
motor module (see figure 26).
2. Push the refill bottle flush to the motor
module until both snaps are secure (see
figure 27).
Note: The red and yellow lights on the
bottom of the soap discharge head
should stop blinking, indicating proper
installation. If the lights continue to flash,
refer to the Troubleshooting Guide.
3. Prime the pump by placing one hand
under the soap discharge head to
activate the motor. Repeat 4 to 5 times
until a consistent shot of foam soap is
discharged (see figure 28).
4. To remove an empty refill bottle, squeeze
the release tabs 1 on the top of the refill
and slide the bottle down 2 and out
(see figure 29).
Fig. 24
Fig. 24
Fig. 25
Fig. 24
Fig. 21
Fig. 23
Fig. 22