Canopy
®
2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 3020964, Revision
-
Assembly Instructions
5.
See completed base
Figure E.
6.
Note: optional, skip to step 7 if no tray was ordered.
Slide tray underneath frame in between tubes and line up
slots on tray with threaded holes on bottom side of tubes.
Attach tray to tubes using M4 Allen wrench key/drive and
remaining button head screws packed with tray.
See Fig-
ure F.
7.
Locate base set screws as shown in
Figure G.
Tighten us-
ing M4 Allen wrench key on both sides of tubes to secure
rails.
8.
Plug Up/Down switch packed in hardware box of base into
ethernet port of control box preassembled on base and run
wire through wire management cut into tube as shown in
Figure G top right corner. Note: This needs to be done
before attaching tops.
9.
Lay worksurfaces on base. Center tops left to right and
6
-
1/16”
off back edge of top to mounting blade of base.
See
Figure H for dimensional requirements
. Attach using
drill/Phillips bit and provided worksurface screws packed
with base.
10.
Attach Up/Down switch into desired location underneath
worksurface through counter sink holes of Up/Down
switch. Attach using drill/Phillips bit and screws packed
with base.
11.
If electrical is attached, see their respective AI
’
s
Figure E
Figure G
Figure F
Set Screws
Up/Down
Switch cord
groove
Control
Box
UP/DOWN
SWITCH
PORT
ACTUATOR
PORT 1
ACTUATOR
PORT 2
Figure H
Button
Head
Screws
Up/Down
switch
6-1/16"
6-1/16"
