Canopy
®
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you have
any questions concerning these instructions, please call Kimball Customer Care.
Part 3033333, Revision A
Assembly Instructions
Media Booth Assembly
Tools Required
•
Box Cutter/Utility Knife
•
Cordless Drill w/#2 Phillips head bit drive
•
M4 & M5 Allen wrench drive
(optional, supplied w/base)
•
1/16”
Allen wrench hex drive
•
Bubble level
Hardware Required
1
-
Bench base
(28FBFBSEP501)
2
-
Media Booth static legs
(28F113018BEBFP)
1
-
H
-
Frame w/L
-
support & crossrails
(28F45HW2C*P)
2
-
Media Booth Canopy
(28F3042CAS*)
2
-
Canopy insert flat plates
1
-
72”
Bench Canopy
(28F7243CAS*)
1
-
Tray
(*optional, pre
-
attached*)
1
-
Rectangular worksurface
(28W2872RT*)
1
-
Round worksurface
(28W28RD*)
2
-
Seat Platform
(28F1830SHLD2)
2
-
Seat Cushions
(28F1830BC)
1
-
End Cap
(provided)
28
-
#10 X .75 Flat Head Wood Screws
32
-
M6 X 12 Button Head machine screws
8
-
Flat Head Phillips M6 X 16 machine screws
52
-
Pan Head Phillips #10 X
5/8”
sheet metal screws
8
-
Pan Head Phillips #8 X 1.5 Flat Wood Screws
(seat assy)
Installation
1.
Refer to bench base assembly instruction for attachment of
bench base.
2.
Using a knife safely open boxes removing static legs, h
-
frames, platforms, tops, seats, canopies and parts bags from
their respective boxes.
See Figure A (package contents).
3.
Locate glides from parts bag in static leg boxes, removing
blue plastic cover and thread into the bottom plate of each
leg.
See Figure B.
4.
Lay both
30”
width canopies on a non
-
marring surface,
face up. Slide flat plates into bottom of canopies aligning
holes. Place static legs on face of canopy as shown in
Fig-
ure B.
Attach legs to canopy using drill/Phillips bit and
#10
-
32 X
3/4”
flat head machine screws.
5.
Locate (4) l
-
brackets and (12 of 28) #10 X 5/8 sheet metal
screws, and line up with pre
-
drilled holes on L
-
support
tube. Attach using drill/Phillips bit.
See Figure C.
Figure A (package contents)
Figure B
Bench Base
*Refer to
bench base AI*
6.
With canopies and static legs supported, stand static legs up
onto glides and hold in place. Slide H
-
frame with L
-
support
over u
-
brackets welded on bench base and static legs. Attach
using M4 Allen wrench key and M6X12 flat head/button
head screws.
Note: button head screws go on bottom of h
-
frame and flat head screws go on the side of h
-
frame. See
Figure C left hand corner.
H
-
Frame w/
crossrails
Static
Legs
Figure C
Bench
Canopy
Media
Booth
Canopy
(2) Media
Booth
Cushion
(2) Seat
Platforms
7.
Refer to center
screen AI for
attaching screen
to H
-
frame.
See
Figure D
to the
right for com-
pletion of this
step.
Figure D
