Kimax HD03WF, Product User Manual, Page: 15 / 16

5. RFQ

A wired USB computer can't make a disk
The first use of the new hard drive requires hard disk initialization, otherwise the disk will not
be used. Only the disk manager can see that the specific steps can be used to "initialize the disk".

Wireless cannot recognize disks
If you can't read the hard drive through WIFI wireless, use a USB cable to connect to the
computer, check the disk properties, see if the disk is not formatted, and whether the disk attributes
are NTFS or FAT32 format. If there is no problem is generally disk fragments too much disk format
(such as the previous computer system disk removed from the old disk, a few partitions as long as
there is a bad partition disk will affect the entire disk mount failed), you need to re-partition the hard
disk or reformat.
Other cable USB storage and wireless storage cannot be used at the same time (link USB data will be
transferred to USB cable wireless will not be able to access disk data).

Wireless relay (if the wireless relay is not successful, it must be the following conditions
which are not satisfied, please check carefully)
First of all, you need to ensure that the upper-layer routing does not have any settings such as
Smart Speed Limit, IP Bonding, MAC Binding, and other restrictions on the client's ability to obtain
Internet access. In addition,the superior routing WIFI password needs to be in more than eight. The
upper-layer routing SSID can not contain spaces and the SSID can not contain characters that contain
Chinese and special symbols. If there is no problem with the above, check whether the WIFI password
of the higher-level route is correct. If there is no problem, configure the relay is complete, please
restart the KI power equipment to see if it can boot automatically connect successfully.
The individual TP-LINK routers need to set the bandwidth and channel in the upper-level routing
wireless settings to be fixed. The default automatic individual router will cause the wireless relay to
fail.
360 free WIFI, advertising commercial WIFI, mobile hot spots and other support unknown.
Wireless trunks can not be used simultaneously with the wired Internet connection. After the wireless
relay is successful If you connect the Internet to a KI device using a wired connection, you need to
go to the KI device first Route Management Interface - Wireless Relay Settings Page - Click the
Disconnect button next to the Trunk Network List. After disconnecting the wireless relay settings, the
power-off reboots the network cable connecting the Internet that can be connected to the KI device
to the KI device WAN port.