Kikusui PWX750ML, User Manual

Page: 54 / 110

54
PWX
Overview
You can use the J1 connector on the rear panel of the PWX750ML to perform the following
types of external control.
• Output voltage control
Controlled using an external voltage or external resistance
• Output current control
Controlled using an external voltage or external resistance
• Turning output on and off using an external contact
• Output shutdown control using an external contact
• Clearing alarms using an external contact
• Monitoring operation modes
About the J1 Connector
Plug kit 749809-9 DB25 is included for connecting to the J1 connector. The plug kit is con-
structed of connector parts made by AMP.
Simple pressure welding tools and contact removal tools are not included. These items must
be purchased separately.
For information about how to use these components, see the AMP catalogs.
For information about how to obtain these tools or replacement parts, contact your Kikusui
agent or distributor.
Attaching the USB cable core
To connect to the J1 connector, requires a core on the cable for connection.
The core is not included. Use an appropriate core.
Recommended core: ZCAT3035-1330 EMI FILTER 250 Ohm 100 MHz by TDK
1
Unlock the snap-on core and open to split.
2
Wrap the cable twice around either half of the
open core.
Wrap the wire so that the distance between the core
and the J1 connector is within 30 mm.
3
Close the core keeping the USB cable from
being wedged in between.
Check that the core is securely locked.
Unlock and
open the core
30 mm
To J1 connector
Core
To connection