Kikusui PLZ-30F, Operation Manuals

Page: 75 / 192

PLZ-U Application Operation 5-17
5.9 Con fi guration Settings
Table 5-2 indicates the con fi guration items.
Table 5-2 Con fi guration settings
*1. Underlined values are factory defaults.
*2. Up to 3 on the PLZ-30F
■
Procedure
Fig. 5-13 Keys for the con fi guration settings and display
CONFIG
Number
Item
Selectable Values
*1
Relevant Function
1 Number of units operating in parallel
1, 2, 3, 4, or 5
*2
Section 5.11, “Parallel Operation”
2 External voltage reference 0, 1, or 2 Section 5.10.2, “CH CONT Connector”
3 Function for turning the load off in the OCP OFF or ON Section, 4.4.3, “Setting the Trip Points”
4 Function for turning the load off in the OPP OFF or ON Section, 4.4.3, “Setting the Trip Points”
5 Delayed load-on time setting 0 ms to 1 s Section 4.2, “Load On/Off”
6 Last load OFF or ON Section 5.6, “Sequence Function”
7 Polarity of the load-on external control H or L Section 5.10.2, “CH CONT Connector”
8 Powering up with the load turned on OFF or ON Section 4.2, “Load On/Off”
9 Communication function selection GPIB or 232 Chapter 6, “Remote Control”
10 GPIB address 1 to 30 Section 6.4.1, “GPIB Control”
11 RS-232C baud rate 2400, 4800, 9600, or
19200 bps Section 6.4.2, “RS-232C Control”
CONFIG number
Configuration setting
Channel display
Load unit Frame