Kikusui PFX2500 Series, Operation Manual

Page: 83 / 144

PFX2512
83
PFX2512 Electric Specifications
5
Specific
a
tions
General specifications
Nominal input rating 100 Vac to 240 Vac, 50 Hz/ 60 Hz
Input voltage range 90 Vac to 250 Vac
Power consumption 60 VAmax (when three OP02-PFXs are installed:
80 VAmax)
Operating temperature and humidity range 0 °C to 40 °C (32 °F to 104 °F), 20 %rh to 85 %rh (no
condensation)
Storage temperature and humidity range -10 °C to 60 °C (14 °F to 140 °F), 0 %rh to 90 %rh (no
condensation)
Operating environment Indoors, overvoltage category II
Altitude Up to 2000 m
Isolation
voltage
I/O terminals
⇔
chassis
±60 Vmax
Insulation
resistance
Primary ⇔ chassis
500 Vdc, 30 MΩ or greater, 70 %rh humidity or less
Primary
⇔
I/O terminals
Withstandin
g voltage
Primary ⇔ chassis
No abnormalities at 1500 Vac for 1 minute
Primary
⇔
I/O terminals
Safety
1
1. Does not apply to specially ordered or modified PFX2512s.
Complies with the requirements of the following directive
and standards.
Low Voltage Directive 2014/35/EU
2
EN 61010-1 (Class I
3
, Pollution Degree 2
4
)
2. Limited to products that have the CE/UKCA mark on their panels.
When the optional OP03-PFX Voltmeter Unit is used, compliance is achieve by using the optional TL12-PFX
sensing cable (length: approx. 3 m, connector area: with cover, with core).
3. This is a Class I equipment. Be sure to ground the PFX2512's protective conductor terminal. The safety of this
product is only guaranteed when the product is properly grounded.
4. Pollution is addition of foreign matter (solid, liquid or gaseous) that may produce a reduction of dielectric
strength or surface resistivity. Pollution Degree 2 assumes that only non-conductive pollution will occur except
for an occasional temporary conductivity caused by condensation.
Electromagnetic compatibility (EMC)
1 2
Complies with the requirements of the following directive
and standards.
EMC Directive 2014/30/EU
EN 61326-1 (Class A
5
)
EN 55011 (Class A
5
, Group 1
6
)
EN 61000-3-2
EN 61000-3-3
Applicable under the following conditions
The maximum length of all cabling and wiring
connected to the PFX2512 is less than 5 m.
Dimensions, weight See the outline drawing. Approx. 17 kg (37.48 Ib)
Weight Approx. 7 kg (15.43 Ib)
Accessories
Power cord
7 1 pc.
Cable with Solderless terminal 4 pcs. (Red : 2 pcs., White: 2 pcs) 45 cm each (17.72 inch)
26-core flat cable 1 pc. DC power supply connection I/F cable
Ferrite core for 26-core flat cables 1 pc.
20-core flat cable 1 pc. Electronic load connection I/F cable
Ferrite core for 20-core flat cables 1 pc.
Sensing connector 1 pc.
Thermistor 1 pc.
Lock lever 2 pcs.
LAN cable 1 pc. Straight type
Operation manual (this manual) 1 copy