Kikusui PFX2500 Series, Operation Manual

Page: 45 / 144

PFX2512
45
2
C
o
nnec
ting and C
o
nfiguring De
vic
e
s
Configuring the Devices
Configuration procedure of devices
p. 45
1
Set the channel numbers and vibration sensor using the S1 switch of the
PFX2512.
p. 47
2
Configure the DC power supply.
Set protection functions, external analog control, and panel lock.
p. 49
3
Configure the electronic load.
Configure the protection function, slew rate, external analog control, panel lockand if
necessary, parallel operation.
Configuring the PFX2512
You can change the following settings using the S1 switch on the rear panel. If you change a
setting, turn the PFX2512 off and then back on.
• Channel numbers
• Vibration sensor
See
See
See
Signal name Logic Notes Factory
default
TERMN OFF
1
1 TP-BUS connector is not used on the PFX2512.
Not used Always set to
ze
0
NC Not used Always set to
zero
0
1
Set channel numbers
(1 to 7).
0 is not allowed.
− 1
2 − 0
4 − 0
8 − 0
RESV Not used Always set to
zero
0
SH DET 0: Vibration sensor off
1: Vibration sensor on −
0
Factory default switch position
Example of channel number 1
S1
SH DET
RESV
8421
NC
TERMN OFF
1 0