Kikusui PFX2500 Series, Operation Manual

Page: 112 / 144

112
PFX2512
Turning the SL01-PFX On and Off
There is no specific order that you need to turn on the system components, namely the PFX2512,
DC power supplies, electronic loads, the SL01-PFX, and other peripheral devices.
Ensure safety before turning the power on or off.
Turning the POWER switch on
1
Check that the power cords and cables of each device are correctly connected.
2
Turn on the POWER switches of the DC power supplies and electronic loads.
p. 47 , p. 49
Check that the protection function and external analog control of each device are
configured properly. If several electronic loads are connected in parallel, specify the
master unit and slave units.
3
Press the (I) side of the rear panel POWER switch to turn the SL01-PFX on.
The POWER/ALARM LED on the front panel lights green.
4
Press the POWER switch on the front panel of the PFX2512 to turn it on (I).
p. 64
5
Check the firmware version on the display.
All the LED on the front panel light for a few seconds, and then only the POWER/
ALARM LED remains lit.
The display shows the firmware version for a few seconds and then the channel
number for another few seconds. Finally, the display enters voltage display mode.
The PFX2512 is ready to execute tests (POWER state) and can receive commands
from BPChecker3000.
p. 59
If the POWER switch is turned on for the first time after purchase, the PFX2512 starts up using
factory default settings.
p. 68 , p. 135
If the ALARM/WARNING LED is lit red, an alarm or protection function may be activated.
See
See
See
See