Kikusui PFX2500 Series, Operation Manual, Page: 64 / 144

64
PFX2512
Turning the Power On and Off
There is no specific order that you need to turn on the system components, namely the PFX2512,
DC power supplies, electronic loads, and other peripheral devices.
Ensure safety before turning the power on or off.
Turning the POWER switch on
1
Check that the power cords and cables of each device are correctly connected.
2
Turn on the POWER switches of the DC power supplies and electronic loads.
p. 47 , p. 49
Check that the protection function and external analog control of each device are
configured properly. If several electronic loads are connected in parallel, specify the
master unit and slave units.
3
Press the POWER switch on the front panel of the PFX2512 to turn it on (I).
4
Check the firmware version on the display.
All the LED on the front panel light for a few seconds, and then only the POWER/STANDBY
LED remains lit.
The display shows the firmware version for a few seconds and then the channel number
for another few seconds. Finally, the display enters voltage display mode.
The PFX2512 is ready to execute tests (POWER state) and can receive commands
from BPChecker3000.
p. 19
If the POWER switch is turned on for the first time after purchase, the PFX2512 starts up using
factory default settings.
p. 68 , p. 135
If the ALARM/WARNING LED is lit, an alarm or protection function may be activated.
Turn on the POWER switches before connecting the DUT (battery).
If there is a problem, the warning function ( p. 70 ) may be able to prevent failure from
occurring.
See
See
Example of firmware version 1.00
A few seconds later
Example of channel number 1
Example of model ID 7101
A few seconds later
See
See