6
PAV LAN
2
Network Connection
This chapter describes the LAN port, LAN configuration, and RS485 multi-drop connection.
LAN port
The LAN port is on the rear panel. The following figure is for the 10 V to 100 V rated output
voltage model, but the LAN port is in the same location on the 160 V to 650 V rated output
voltage model.
No. Name
Function
1
LAN port
RJ-45 port for LAN connection.
2
Link LED
Green solid: When the PAV is connected to LAN.
3
Activity LED
Orange blinking: When a message packet is
detected.
4
LAN sta-
tus indica-
tor LED
Normal operation
Green solid: When the PAV can connect to LAN.
PAV identification
Green blinking
1
,
2
1
You can use the identification function by accessing the webpage from a PC or the like or by
sending an SCPI command. When used, this LED blinks in sync with the front panel display.
This function is useful to identify which PAV you are controlling when there are several PAVs
mounted in the rack. If the PAVs are connected in a multi-drop configuration, only the LED of
the PAV with LAN (master unit) blinks.
2
To stop this blinking, click Blink Identify
on the webpage, send an SCPI command
, or turn or press the setting knob of the front panel.
LAN fault
Red solid:
When the PAV is not in LAN remote mode, when a
LAN connection failed to be completed, or when the
LAN connection is disconnected.
1
2
3
4
