Kikusui PAT160-25T, Operation Manual

Page: 59 / 218

PAT-T 4kW
4-17
4
B
a
s
ic O
p
er
a
ti
on
CONFIG parameter details
CF01 Alarm cause display
Displays the cause of the alarm occurrence (while the ALARM LED is illuminated).
If there are multiple causes, the sum of each cause is displayed.
CF02 Remote sensing status display
p. 4-26
Displays the state of the sensing switch on the rear panel.
CF10 Output on delay setting
p. 4-5
Set the delay from the time the OUTPUT switch is pressed until the output turns on.
When exiting from the CONFIG settings by the OUTPUT switch, the output on
delay function is activated at the some time for which setting conditions were set by
the output on delay settings.
CF11 Output off delay setting
p. 4-5
Set the delay from the time the OUTPUT switch is pressed until the output turns off.
When exiting from the CONFIG settings by the OUTPUT switch, the output off
delay function is activated at the some time for which setting conditions were set by
the output off delay settings.
Display Description
0 N ot an alarm condition (ALARM LED is off)
1 Overvoltage protection (OVP)
2 Overc u rrent protection (OCP)
4 overheat protection (OHP)
8 Inp u t open-phase protection (PHASE)
16 Incorrect sensing connection protection (SE N SE)
32 Fan fail u re protection (FA N )
64 Sh u t do w n (SD)
12 8 Overheat protection of the bleeder circ u it (BOHP)
See
Display Description
oFF Remote sensing is off
on Remote sensing is on
See
Settings Description
oFF N o delay (factory defa u lt)
0.1 to 10.0 O u tp u t on delay. Unit: s, resol u tion: 0.1
See
Settings Description
oFF N o delay (factory defa u lt)
0.1 to 10.0 O u tp u t off delay. Unit: s, resol u tion: 0.1