Kikusui KFM2151, Operation Manual

Page: 90 / 112

4-36
KFM2151
Remote Control
Preset Status
STAT:PRES
Specific events are reported at a higher level by constructing status data and using
the status reporting mechanism. These events are summarized in the required
structures, OPERation status register, and QUEStionable register.
STAT:PRES only affects the ENABle register and the transition filter register of the
status data structure.
STAT:PRES does not clear any event registers or any items from the error/event
queue.
To reset all event registers and the queue within the device status reporting
mechanism, use *CLS.
For status data required by SCPI, the STAT:PRES command sets the transition filter
registers so that only positive transitions are detected and sets the ENABle register
to all zeroes. The settings of the service request enable register, parallel poll enable
register, output queue, and power on status clear flag are not affected by this
command.
For the device-dependent status data structure, STAT:PRES sets the ENABle
register to all 1s and sets the transition filter registers so that only positive transitions
are reported.
Ta b le 4- 8 Preset v al u es of registers that can b e set b y the u ser
Command
STATus:PRESet
Register Filter/Ena b le Preset V al u e
Req u ired stat u s data
Operation
QUEStiona
b le
Ena b le register All 0s
Positi v e transition filter All 1s
N egati v e transition filter All 0s
De v ice-dependent stat u s data Ena b le register All 1s
Positi v e transition filter All 1s
N egati v e transition filter All 0s