Kikusui KFM2151, Operation Manual

Page: 63 / 112

KFM2151
4-9
Remote Control
■
Numeric
A numeric parameter such as a decimal point, option symbol, or measurement unit.
The syntax as a numeric representation is the same as NRf.
MINimum, MAXimum, and DEFault are available as substitutes for declaring
certain values.
Units such as V, A, and W can also be used in a numeric parameter.
If a value that cannot be assigned is entered, the device rounds the value to the
closest possible value.
VOLTage:RANGe 250
Because the range setting is 2 to 200, 200 is returned in response to VOLT:RANG?.
Special form numeric parameters
The special form numeric parameters MINimum, MAXimum, and DEFault can be
used as substitutes for limit values when the parameter is numeric.
In the example below, the voltage protection (UVP) is set to the minimum value.
VOLTage:PROTection:LOWer MINimum
The minimum and maximum values can be inquired for most parameters using
queries.
VOLTage:PROTection:LOWer? MIN
VOLTage:PROTection:LOWer? MAX
Measurement unit
Below are the default measurement units.
• V (voltage)
The following optional prefixes are supported.
• M (milli) • K (kilo) • U (micro)
• The unit symbols in the International System of Units contain lowercase
characters. The IEEE standard uses uppercase characters. SCPI commands are
not case sensitive.
• Commands are accepted even if a measurement unit are not specified.
• To enter “µ” in the data, use “U” instead.