Kikusui KDS6-0.2TR, Operation Manual

Page: 49 / 60

KDS6-0.2TR Remote Control 45
4.4 Message Table
A table of the remote interface messages is given below. R/W represents the query
message (R) or command message (W).
Table 4-3
†
1: For more information, refer to the detailed description for each message.
Header
Data
Function and response data
R/W Min Max Resolution Unit
1 SILent W OFF(0) ON(1) – – Acknowledge message (RS-232C)
2 *RST W – – – – Device initialization (resets to factory-settings)
3 *IDN? R – – – –
“KIKUSUI ELECTRONICS CORP.,KDS6-0.2TR,0,x.xx”
is returned.
(x.xx is the version No.)
4 ERR? R – – – – An error register value is returned to clear the error register.
5 *STB? R – – – – A status byte register is read out.
6 *SRE R/W 0 255 1 –
Setting of service request enable register/read-out of setting
value
7 *CLS W – – – – Clearing of status byte register
8 V1Set R/W 0.0000 6.5000 0.0001 V Channel-1 voltage setting or read-out of setting value
9 V2Set R/W 0.0000 6.5000 0.0001 V Channel-2 voltage setting or read-out of setting value
10 V3Set R/W 0.0000 6.5000 0.0001 V Channel-3 voltage setting or read-out of setting value
11 VSET R/W 0.0000 6.5000 0.0001 V
En-bloc setting or read-out of Channel-1 to Channel-3 out-
put voltages
12 I1Out? R – –
†
1
mA
Read-out of Channel-1 output current value
If OCP has occurred, “CH<n>OCP” is returned (n = 1 to 3).
13 I2Out? R – –
†
1
mA
Read-out of Channel-2 output current value
If OCP has occurred, “CH<n>OCP” is returned (n = 1 to 3).
14 I3Out? R – –
†
1
mA
Read-out of Channel-3 output current value
If OCP has occurred, “CH<n>OCP” is returned (n = 1 to 3).
15 IOUT? R – –
†
1
mA
En-bloc read-out of Channel-1 to Channel-3 output volt-
ages
If OCP has occurred, “CH<n>OCP” is returned (n = 1 to 3).
16 OUTPut R/W OFF(0) ON(1) 1 –
On/off or status read-out of all-channel outputs
To clear OCP, OUTPut Off or OUTPut 0 is sent.
17 RANGeset R/W 0 1 1 –
Switching/inquiry of current range of Channel 1
0:10 mA 1:200 mA
18 SAMPlerate R/W 0 1 1 –
Switching the sampling rate of the output ammeter
0: Normal mode
1: High-speed mode
19 KEYLock R/W OFF(0) ON(1) 1 – Locks all keys but the LOCAL key.
20 ACHSel R/W 0 1 1 –
On/off setting of the function to switch panel indication
with every voltage setting or current read-out