Kikusui DSI1020, Installation Manual, Page: 51 / 64

DSI1020/ DSI3020
51
AppendixA
AC Power Supply Connection Diagram
PCR-LE series
One PCR-LE DSI1020
INPUT
G N L
OUTPUT
G N L
OUTPUT
G N L
PCR-LE Series AC Power Supply
DSI1020 Dip Simulator
SLOT3
SLOT1
AUX
PHASE IN
To the PC
(GPIB, USB, or LAN)
Connect to the EUT
or relay terminals.
To the PC (RS-232C)
SLOT4
SLOT2
1
2
3
4
Install the control board supplied
with this product in SLOT3.
To use the GPIB, USB, or LAN interface, install the
appropriate board in SLOT4.
To use RS-232C, use the RS-232C terminal on
the front panel.
1P2W Connectable EUT input circuits
Start point End point Cable
1
Signal connector
(PCR-LE rear panel SLOT 3)
PHASE IN connector (DSI1020) Control cable (supplied with this product)
2 Output terminal L (PCR-LE) Input terminal L (DSI1020)
Single-core wire
1
3 Output terminal N (PCR-LE) Input terminal N (DSI1020)
Single-core wire
1
4 Output terminal G (PCR-LE) Input terminal G (DSI1020)
Single-core wire
1
1 This product does not include wires for connecting devices or crimping terminals for the wires. Check the screw sizes
of the I/O terminals of devices in use, and use appropriate single-core wires and crimping terminals. (See
“Connecting
wires,” on page 20 .) We recommend that you use wires with a nominal cross-sectional area of at least 8 mm
2
(AWG8).