19
JMNC Operating Instructions
5 Mounting and Dismounting
Attention!
We recommend you to pull the rotational
speed monitoring device (9) straight off the
base (10), because the plug contacts (11)
could break off.
4. Drill the punched mounting bores (
13
) in the base
bottom by means of a 4.5 mm driller (
5. Drill the fastening holes, and tightly fasten the base
(
10
) by means of two suitable M4 screws.
6. Make the electrical connection
7. After the electrical connection, plug the rotational
speed monitoring device (
9
) back onto the base (
10
)
and fasten the screws.
Attention
Make sure that the rotational speed monitoring
device (9) is plugged in the correct position!
Take care that the plug contacts (11) are
plugged into the terminal strip of the base.
Fig. 5-2: Mounting to rotational speed monitoring device
rotational speed monitor-
ing device (
9
)
base (
10
)
plug contacts (
11
)
screws (
12
)
mounting bores (
13
)
