A
Page 14 / 30
Product Description
RPW404P-FTL
Datasheet 1.10-65.030-01-EN
Issue 2017-04-03
Default utilization time profile:
NOTE
Once the procedure is complete, it is not possible to add an additional wireless small actuator.
If you want to do so, you must teach in
all
wireless small actuators again.
NOTE
If the room control module was already switched on, the “Switching on the device” item is skipped
and the room control module uses the utilization profile that is already taught-in.
Mounting
The room control module can be stuck to smooth, flat surfaces using the wall mount and the adhesive
pad supplied, or it can be screwed directly onto level surfaces.
Screws and wall plugs are not included in the scope of delivery of the room control module.
WARNING
Flush mounted cabling and piping at the installation location (electricity, gas, water)
Cabling and piping can be damaged by drilling.
Check the installation location for flush mounted piping and cabling, or contact a specialist.
NOTE
Position the wall mount so that the bar (1) can be easily accessed. Ensure a distance of at least 10 cm
from other objects (door frames, electrical sockets, cupboards, etc.).
NOTE
Observe the orientation of the wall mount. The bar (1) must be on the right-hand, lower side when the
device is installed, see figure 4.
Use the enclosed adhesive numbers (2) to uniquely identify the mounting location and the respective
room control module.
►
Mark the room control module and the wall mount with a unique number using the enclosed
adhesive numbers (2).
Room used:
6:00 AM - 8:00 PM, comfort temperature
Room unused:
8:00 PM - 6:00 AM, economy temperature
