2. Programming Your Vocal Smoke Detector
Quick Programming Guide
The Vocal Smoke Detector must be programmed PRIOR to
mounting. Failure to comply with this recommendation will
transform your Vocal Smoke Detector into a regular smoke alarm
with a loud horn alarm and no customized message.
Engaging the Batteries
1. Remove the mounting bracket from the unit.
2. Remove the yellow Battery Pull Tab from the back of the unit.
Removing the tab will engage the batteries to power the unit.
3. Turn the unit over and make sure a red light is briefly flashing
once every 40 seconds. The red light indicates your unit is
now battery powered and you are ready to record your
personal message.
Recording Your Message
(refer to next section for effective message examples)
1. Turn over the unit.
You will see a MIC at the top of the unit and a button on the
bottom that says Record/Play.
2. To record your message, press and hold the “RECORD/Play”
button and speak very loudly and seriously into MIC after
the beep.
3. To end recording, release the “RECORD/Play” button.
6
23
Repair
CAUTION! Do not attempt to repair this alarm. Doing so will void
your warranty.
If the alarm is not operating properly, see “Troubleshooting.”
If necessary and if still under warranty, return the alarm to
KidSmart Corporation as described in the Warranty and Service
Information section of this instruction manual.
5-25 paginated.qxd 5/25/2004 5:28 PM Page 16
