22
“Movement is life!”
H. REMOVAL AND INSTALLATION OF REAR WHEELS
** REMOVE THE CHILD FROM THE CHAIR
1.
To remove the wheels:
a. Release the wheel locks.
b. Press the button in the center of the wheel on the quick
release axle.
c. With the same hand, pull on the wheel to remove the wheel
and axle from the chair.
2.
To install the wheels:
a. Make sure the wheel lock lever is released.
b. Put the axle through the wheel hub if necessary.
c. Hold the axle and wheel. Align the axle with the axle sleeve on
the chair.
d. Press the button on the axle and slide the axle into the axle sleeve.
e. Make sure that the axle is fully engaged by verifying that the
button on the top of the axle pops out.
Verify that pin
is fully engaged
(button up)
Figure 27: Installation of Quick Release Axle
I. USE OF OPTIONAL THERAPY TRAY
Tray Installation and Removal:
1. Align the two tray posts with the tray receivers on the chair.
2.
Push the tray posts into the receivers.
3. To remove, pull tray out of tray receivers.
4. Remove the therapy tray when using chair in transport.
Tray Height Adjustment:
1.
Fig. 29
shows tray in highest adjustment position.
2. To allow lower tray position remove nut and bolt from both sides of tray
support using 7/16” nut driver and 5/32” hex driver.
Figure 28: Tray Receivers
Figure 29: Tray in highest
position
Figure 30: Tray in lowest
position
A
WARNING: Tray must not be loaded with objects
heavier than 11 lbs (5 kg).
WARNING: Tray must be removed from chair dur-
ing transport in a motor vehicle.
