1. ATTACH THE ANCHOR STRIPS
1. Carefully measure all sides of the opening to be
protected with the net and calculate the number of the
anchor strips needed for every side.
2. Make sure that the hooks are evenly distributed (7 cm)
along the anchor strip. The first and last hook should be
placed 3.5 cm from the edge.
1
3. Hooks can be moved by applying slight pressure
towards the anchor strip. To remove or place the hook
on the anchor strip, rotate it by 90 degrees.
2
4. After distributing the hooks evenly, mark the places on
the anchor strip where the holes for the screws will be
drilled. Each anchor strip should be attached with the 5
screws to the base. Place the holes every 25 cm: two at
the end, one in the middle and two in between. Drill the
holes for the screws using the 4mm drill bit.
3
5. Place the anchor strip on the base and mark the
position of the holes on the base.
6. Drill the holes in the base. Depending on the type of
base, use 6mm drill bit for concrete or 3mm drill bit for
wood and metal. If applicable, put the dowels into the
holes. Attach the anchor strip using appropriate screws.
4
7. Cut the last anchor strip with a small saw for metal to
adjust its length to the remaining space on the base.
8. Use anchor strips to entirely cover all sides of the
opening.
2. PLACE THE NET
When all anchor strips are mounted, start placing the
net. Only use hands. Sharp objects can damage
the net.
1. Hook the net in one of upper corners. Hook entire top
side. Hook left and right side from the top downwards.
Hook bottom side from the corners towards center.
5
2. First rhombus is hooked onto two anchors (top and left
/ top and right).
6
3. When this is done, check if the net is attached to all
anchors / hooks.
4. Check the tension of the net pushing it mildly with
palms. It should have right tension: not too tight, not
too lose. If needed, make little adjustments by moving
the hooks slightly along the anchor strip.
3. CUT THE EXCESS OF THE NET
1. Provided the net is properly mounted and tensed and
entirely attached, use scissors to cut the excess of net.
ATTENTION!
It is only allowed to cut the loose end of
the net, on the outer side of anchor strips. Do this with
caution, ensuring to leave the knots intact.
6
2. Congratulations! If you carefully followed the
instructions, your net is installed correctly!
INSTALLATION MANUAL
1
2
4
3
6
5
