29
2 x
Heavy SW Post 50.8 x 76.2 x 2201.9mm
1 x
SW Upright 76.2 x 76.2 x 1294.3mm
1 x
SW Support 23.8 x 82.6 x 1181.1mm
Step 7: Swing End Assembly
A:
Loosely attach 2 (2613) Heavy SW Posts to (2615) SW Upright using 2 (G7) 5/16 x 5-1/2” Hex Bolts (with
lock washer, flat washer and t-nut). Notice 2 bolt holes at top of (2615) SW Upright and orientation of angle.
(fig. 7.1)
B:
Attach (2616) SW Support to both (2613) Heavy SW Posts and (2615) SW Upright using 3 (G4) 5/16 x 4”
Hex Bolts (with lock washer, flat washer and t-nut). Tighten all bolts. (fig. 7.1)
C:
Install 2 (WB7) 5/16 x 3” Wafer Bolts (with flat washer and t-nut) in the top bolt holes in (2615) SW Upright
as shown in fig. 6.1.
IT IS IMPORTANT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE
CHECKING OF WOOD.
Hardware
Wood Parts
2 x
Hex Bolt (lock washer, flat washer, t-nut)
3 x
Hex Bolt (lock washer, flat washer, t-nut)
2 x
Wafer Bolt (flat washer & t-nut)
G7
WB7
G4
Notice 2 bolt
holes at top and
orientation of
the angle
WB7
Fig. 7.1
2613
2615
2613
2615
2616
G7
2616
G4
TN2
FW2
TN2
TN2
FW2
FW2
LW2
LW2
