Component Checklist:
Component Checklist:
•
Rechargeable Drifter Car
•
Remote Control
•
Water Syringe
•
USB Charging Cable
Battery Instructions:
Battery Instructions:
1.
Make sure the power switch is set
on the OFF position.
2.
Locate the battery compartment on
the bottom of the car and unscrew
the battery cover.
3.
Connect the battery to the USB
charging cable.
4.
Charging Time approximately 3
hours.
1.
Locate the battery compartment
2.
Unscrew the cover and insert (2) AA
batteries (not included) according
to the indicated polarity marks
(+/-).
3.
Close the cover and re-tighten the
battery cover screw.
Charging Instructions
Battery Installation
Vapor Spray Mode:
Vapor Spray Mode:
Remote Controller Directions:
Remote Controller Directions:
Squeeze syring to fill with
water.
Left
Sound Effect
Switch
Right
Demo
Mode
Rotate Left/
Rotate Right
Forward/
Backward
Indicator Light
Launch Vapor
Press the spray button remote
to activate vapor.
Open the water injection port
and fill with clean water.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil contient des émetteurs/récepteurs exemptés de licence qui sont conformes
aux flux RSS exemptés de licence de Innovation, Science et développement économique
Canada. L’exploitation est soumise aux deux conditions suivantes:
Cet appareil ne doit pas causer d’interférences.
Ce dispositif doit accepter toute interférence, y compris toute interférence pouvant causer
un fonctionnement indésirable du dispositif
