Kiddy Rides Peppa Pig Carousel, Operator'S Handbook Manual

Page: 9 / 27

Standard Operation And Adjustments
Control Box / Timer
- The control system in this ride is a Low Voltage ‘Kermit Navigator’ box.
This is located inside the centre column. It is accessed by removing the 4 bolts around the lid on the
top of the column and lifting it upwards. These can be removed using a 4mm hex/allen key. There is a
small connector to enable you to disconnect the loom and remove the lid completely, or for simple
inspection, access can be gained through the coin mech area, but space will be limited.
Once the lid is removed, it leaves the Kermit Box, and its connections easily accessible.
If required, the box can be removed from the ride by loosening the two 7mm nuts which hold the
mounting tags.
*Do not remove the nuts fully. This will eliminate any chance of dropping them
into the Kermit Box. Once the nuts are loose, simply pull the bottom of the box towards yourself,
disengaging the lower mounting tag. The top two tags which you have just loosened should now drop
free from the bolts.
*Ensure all connections to the Kermit Box are disconnected before removal.
Ride Time
- The length of time that each ride lasts is determined by the interactive game, and can
not be changed. The standard length for each ride is approximately 90 seconds.
Volume Settings
- The volume control buttons are located on the right hand side of the control box
as indicated by the diagram on the box lid. Here you will find 2 small push buttons, one to turn the
volume up “+” and one to turn the volume down “-”
(The power must remain on, and the ride should be
running to adjust the volume settings on this control system).
Volume Controls
Fig 1.
7