• Smoke, heat, and combustion products rise to the ceiling and spread
horizontally. Mounting the smoke alarm
on the ceiling in the center of the room
places it closest to all points in the room.
Ceiling mounting is preferred in ordinary
residential construction.
• For mobile home installation, select loca-
tions carefully to avoid thermal barriers
that may form at the ceiling. For more
details, see MOBILE HOME INSTALLATION
below.
• When mounting an alarm on the ceiling,
locate it at a minimum of 4” (10 cm)
from the side wall (see figure 1).
• When mounting the alarm on the wall,
use an inside wall with the top edge of
the alarm at a minimum of 4” (10 cm)
and a maximum of 12” (30.5 cm) below
the ceiling (see figure 1).
• Put smoke alarms at both ends of a hall-
way or large room if the hallway or room
is more than 30 ft (9.1 m) long. For large
rooms, one smoke alarm is recommended
for every 500 square feet of floor space.
• In homes that are not well insulated,
extreme heat or cold can be transferred
from the outside to the inside through
poorly insulated walls and roof. This may
create a thermal barrier which can pre-
vent the smoke from reaching an alarm
mounted on the ceiling. If you are not
sure about the insulation in your home,
or if you notice that the outer walls and
ceiling are either hot or cold, install the
alarm on an inside wall. In such homes,
install the smoke alarm with the top edge
of the alarm at a minimum of 4” (10 cm)
and a maximum of 12” (30.5 cm) below
the ceiling (see figure 1).
• Install Smoke Alarms on sloped, peaked
or cathedral ceilings at or within 3ft
(0.9m) of the highest point (measured
horizontally). NFPA 72 states: “Smoke
alarms in rooms with ceiling slopes great-
er than 1 ft in 8 ft (.3m in 2.4 m) hori-
zontally shall be located on the high side
FIGURE 1
FIGURE 3
FIGURE 2
ANYWHERE ALONG
THIS BOLD SURFACE
12”
(300mm)
FIGURE 4
0475-7208-00(820-0895-EN)_R1.indd 3
0475-7208-00(820-0895-EN)_R1.indd 3
2009.12.9 10:23:11 AM
2009.12.9 10:23:11 AM
