This pushchair requires regular maintenance by you.
Regularly inspect the locking devices, brakes, harness assembly, catches, joints and
fixings to ensure they are secure and in full working order.
Brakes, wheels and tyres are subject to wear and should be replaced if necessary. This
can be arranged at kiddicare store,
Should parts of your pushchair becomes stiff or difficult to operate, ensure that dirt is not
the cause, then try light application of a silicon-based lubricant, ensuring that the
lubricant penetrates between the components, but do not over spray as this may
encourage the accumulation of dirt. Regular lubrication of moving parts will extend the
life of your travel system, and make opening and folding easier.
Plastic and metal moving parts may be sponged clean with warm water and mild
detergent.
Refer to sewn in labels for fabric care instructions.
Allow to dry thoroughly before storing.
Never clean with abrasive, ammonia based, bleached based of spirit type cleaners.
After exposure to damp conditions, leave fully opened fully opened and in warm
environment. Dry of with a soft cloth. Storing a damp pushchair will encourage mildew to
form.
Store your pushchair in a dry place.
Parts list
Car seat adaptors
Chassis frame
Fabric seat unit
Front wheels
Rear wheels
Bumper bar
Raincover
Hood
Footmuff
Harness
Press the center button on the buckle to release,
open harness clips on either side of the buckle
(fig.18)
Under 6 months:
Adjust shoulder straps by selecting one of the
three height positions and using the buckle as
labeled.
Thread shoulder harness from back of the seat
unit through to the front of the seat.
Waist straps are adjusting to fit smaller baby/child
by threading through the loops in the middle seat.
Over 6 months
Adjust shoulder straps as above and select
suitable waist harness length before straps goes
though loops.
Thread shoulder harness from the back of the seat
unit through to the front of the seat
maintenance
assembly
2. 7. 6. 3. 4. 5.
18
Car seat adaptor
Attach adaptors by inserting by inserting into the holes on the chassis frame push and
lock in to place (fig.19)
Ensure the adaptors are fully engaged before placing infant carrier onto frame, push
down firmly (fig.20)
20
19
2. 7. 6. 3. 4. 5.
2. 7. 6. 3. 4. 5.
