The correct width will be reached by adjus-
ting gate sections and all four corner spind-
les. Each spindle adjusts individually and
may be extended to varying lengths to allow
for molding, uneven walls, etc. Spindles may
be extended a minimum af 1” but not more
than 4” on each side.
Adjust gate sections until gate is approxi-
mately right width and adjustment holes are
aligned top and bottom. Sections should fit
without any distance between bars.
Gate sections must not be extended any
further than 4 adjustment holes from
spindle ends of gate and holes must
overlap at two places on both the top
and bottom railing.
Place one set of expansion screws and
screw sockets (i and j) in top and bottom set
of overlapping adjustment holes nearest hin-
ge side of gate and second set of expansion
screws and screw sockets in overlapping
holes nearest locking side of gate. Tighten
with screwdriver.
Push stabilizing foot (p) into vertical tube.
Use of stabilizing foot is optional unless one
or more (maximum 4) optional extensions are
used.
6
